Make sure the straps are not too tight (the straps attached to the central
ring must be tight), fully inflate the airbag (see operating instructions). Once
the airbag is fully inflated, tighten the straps. These straps prevent
forward/backward movement of the airbag once inflated. The straps will be
loose when the airbag is deflated.
Caution, do not over tighten the straps, this could cause damage to the
retaining rings on the airbag and straps during the inflation process.
Caution, there are two straps wider than the others. These straps should
be installed around the airbag before it is slipped under the dock. Due to
excessive water displacement exerted by some boats when backing off into
the water, these straps prevent an overload on the other straps that could
break.
You must pass the straps around the airbag and once it is in place and the
other straps are in position. Inflate the airbag and then place the straps around
the screw that attaches the corner cube to the Jetslide as in the following
pictures.
Caution, tighten the straps to their maximum (no exaggeration) only when
the airbag is fully inflated and without load on the system.
