Candeo Rotary Wifi Dimmer Switch - C302-WF
For further support please go to www.candeo.io
Change the dimming mode
1. To switch to Leading Edge:
i. Turn the light on and press the knob 5 times, with a long press on the 5th time.
ii. The light will blink 5 times to indicate Trailing Edge mode.
2. To switch to Trailing Edge
i. Turn the light on and press the knob 4 times, with a long press on the 4th time.
ii. The light will blink 3 times to indicate Trailing Edge mode.
Troubleshooting
If your lights will not turn completely off, or they are flickering at low levels:
Diagnosing this issue can be complicated and often dependent on many variables that are unique to the wiring
in your house.
However, the most common cause is due to either the total load of the lights being too low, or the wattage of
one particular bulb being too low. Please ensure that each lamp is minimum 5W although 10W+ will give better
results. Please also ensure that the total load is minimum 10W.
If the problem persists, please try increasing the minimum brightness setting of the switch by following the
steps above.
If increasing the minimum brightness did not solve the problem, we suggest either increasing the load on the
circuit by using higher power lamps, or by fitting an LED bypass over the first lamp in the circuit.
Instructions version: 2209.2
It is possible to change the dimming mode from Trailing Edge to Leading Edge (and vice versa). The default
dimming mode is Trailing Edge and is suitable for most modern lighting applications. Should you need to
change the dimming mode, please follow these steps:
