Candela C-8 2023, Руководство пользователя

Страница: 20 / 55

38 39
Systems Systems
Bilge pumps
To detect and remove water, the C-8 has three bilge pump positions:
• 1 automatic aft bilge pump – drains the rear stern
• 1 aft manual bilge pump – drains the front stern
• 1 automatic front bilge pump – drains the bow
A
A B C
B C
A
The two automatic bilge pumps run every other minute, pumping out the excess water from the
bow and rear stern. They generate a faint buzzing sound while active. If necessary, the two auto-
matic bilge pumps can be activated manually via the user interface.
The automatic bilge pumps are electrical and remain active when the key is turned off. They will
not function if the 12V battery switch is turned off, or if the boat suffers from power loss.
The manual bilge pump is located under the sunbed hatch and is only used if excess water has
accumulated in the stern. This water is pumped out by hand.
A.
Automatic Aft bilge pump
B. Manual bilge pump
C. Automatic Front bilge pump
WARNING! Risk of flooding. If water enters the boat due to damage, do not rely on the
bilge pump system. The bilge pump system is not designed for damage control.
NOTICE! When the 12V battery switch is off, the automatic bilge pumps will not work.
NOTICE ! Check the bilge pumps regularly and keep the bilge pump drain outlets clear
from debris.
Checking the automatic bilge pumps
To check the function of the automatic bilge pumps, wait for them to start, or start them manually:
1. In the Outputs settings in the user interface, start each of the automatic bilge pumps.
2. A faint buzzing sound and the sound of splashing water indicates that the bilge pumps are
functioning.
3. If necessary, perform a visual check:
a. Open the sunbed hatch and make sure there is no excess water in the stern.
b. In the cabin, unscrew the hatch to the front bilge pump and make sure there is no excess
water in the bow.
A
A B
B
A. Check under sunbed hatch
B. Check cabin inspection hatch