C&D Technologies Liberty DCS, Техническое руководство

Страница: 7 / 38

RS02109/0814/CD 7 www.cdtechno.com
Part 3 - Safety Precautions
This battery is designed for industrial, stationary use only and is not intended for application in
vehicular, starting, lighting and ignition (SLI), and the operation of portable tools and appliances.
Use in accordance with this manual or all IEEE battery procedures. Use of this product other than in
accordance with these instructions may produce hazardous and unsafe operating conditions, leading to
damage of equipment and/or personal injury.
Do not expose the batteries to open flame or electrical arc. Do not tamper with the vent, as this will
void the warranty.
Do not use any petroleum based cleaning or lubrication solution on the battery jar or cover. Failure to
follow this warning may result in damage to the container and will void the warranty.
As a notice to all technicians and personnel in the near proximity of the batteries, a BCI warning label is
in plain view to indicate the potential hazards of battery systems.
Figure 1 - BCI warning label
3.1 Recommended Tools
The below lists are general recommendation and is not intended as a complete and specific list. Each
installation may require special tools that cannot be identified without knowing the specific applications.
Review the appropriate industry recommendations, state and local codes for the specific information.
3.2 Personal Protection Equipment (Safety)
•
Use standard battery safety practices
•
Rubber or Neoprene – Acid Resistant Gloves
•
Protective apron
•
Face shield/safety glasses or ANSI approved goggles
•
Rubber soled safety shoes/boots
•
Portable or permanent eye wash station