27
7.1.3 Connect
HIT-3MF3HDMI-641RIPRO
and PC
You must power off the
HIT-3MF3HDMI-641RIPRO
Switcher. Then, connect the
Switcher RS-232 port to the PC RS-232 port with the bundled communication cable.
And make sure the DIPs on the rear panel are set to Master and RS-232. (Refer to
the previous section
6.5.1 RS-232
)
7.2 Switcher Configuration
After finishing installation, click
to active AV Matrix Application. In the
“Options”
window, select the connected PC Port number and Baud rate, and then click
“OK”
.
Figure 7-2 AV Matrix Options Window
The software controls signal connection between the corresponding input port and
output port as required. The AV Matrix software application main window is shown as
below:
Figure 7-3
《
AV Matrix
》
Software Application Main Window
