Canature WaterGroup 95STS, Инструкция по установке и эксплуатации

Страница: 9 / 32

8 9
MENU SET & REGEN
Last Regeneration: 2023.05.12
Meter
Capacity
Remaining
Flow
Rate
08:30
Advancing to Service
Wait Please
SYSTEM START-UP
PROGRAMMING INSTRUCTIONS
START-UP INSTRUCTIONS
1. Plug the valve into an approved power source.
2.
When power is supplied to the control, the screen will display “Advancing to Service Wait Please” while it finds the service position.
3. If screen is locked, press MENU for 3 seconds to unlock. Press and hold the SET / REGEN button for 3 seconds to enter the manual regeneration
screen. An option for delayed or immediate regeneration will appear. Press SET REGEN, then press the DOWN button to select IMMEDIATE. Press
the MENU button to save setting and immediately start moving to the BACKWASH position.
4.
Open the inlet on the bypass valve slowly and allow water to enter the unit. Allow all air to escape from the unit before turning the water on
fully then allow water to run to drain for 3-4 minutes or until all media fines are washed out of the softener indicated by clear water in the drain
hose.
5. Press any button to advance to the BRINE position. Check the water level in the brine tank to insure the valve is drawing brine properly.
6.
Press any button to advance to the RINSE position. Check the drain line flow. Allow the water to run for 3-4 minutes or until the water is clear.
7. Press any button to advance to the REFILL position. Check that the valve is filling water into the brine tank. Allow the valve to refill for the full
amount of time as displayed on the screen to insure a proper brine solution for the next regeneration.
8. The valve will automatically advance to the SERVICE position. Open the outlet valve on the bypass, then open the nearest treated water faucet
and allow the water to run until clear, close the tap and replace the faucet screen.
9. Add salt into the brine tank.
KEY PAD CONFIGURATION
CHANGE SETTING PROCEDURE
1.
Press the MENU button to enter and exit the menu.
2. Press the UP or DOWN button to select the parameter.
3.
Press the SET/REGEN button to enter or activate the parameter for editing.
4. Press the UP or DOWN button to change the value.
5.
Press the SET / REGEN button to save the value.
6. Press the UP or DOWN button to select other parameters.
7.
Follow the above steps to change other parameters.
8. Press the MENU button to save and exit settings.
You can only change flashing parameters.
MAIN DISPLAY
When power is first supplied, the valve may take up to two
minutes to find the service position. During this time the valve
will show:
MENU - Enter or exit the system menu. Press and hold the
button for 3 seconds to unlock the screen.
SET/REGEN - Press this button to select a program or to save the
settings. Press and hold the button for 3 seconds to
initate a manual regeneration.
DOWN / UP -
Press these buttons to increase or decrease the value of
the settings. Press the buttons to enter the previous or
the next menu.