Pg. #6
Pg. #7
2
2
.
.
MOUNTING
DOWNROD MOUNT
A
A
3
3
.
.
INSTALL MOUNTING BRACKET
- Install J-Hook through centre of outlet box and into the wooden joist.
- Secure mounting bracket and rubber gaskets to outlet box.
- Hang the safety cable onto the J-hook.
-
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Support And Use Mounting Screws Provided With The Outlet Box.
FLUSH MOUNT
B
B
Canopy
Rubber Ring
Motor
Canopy
Yoke Screws
& Washers
Rubber Bushing
FLUSH MOUNT
- Remove rubber ring from canopy.
- Place canopy on fan housing by aligning 3 larger holes of canopy over
3 existing screws on the motor housing.
- Secure canopy to motor housing by placing 3 screws and washers
(supplied in hardware package) in the 3 smaller holes in the canopy.
B
B
- Insert bolt through hole in shaft and downrod.
Be careful not to
damage or cut the fan wires.
- Tighten flat washer and bolt. Secure with cotter pin through hole in the
end of the bolt.
- Secure downrod in position by tightening jam screws. Slide yoke cover
down so it is flush with the motor housing.
Motor
Jam Screw
Yoke Cover
Downrod
Canopy
Fig.
3c
Fig. 3d
Fig. 3e
Cotter
Pin
Jam Screw
Bolt
Yoke
Yoke
Jam Screw
Flat Washer
Fig. 3a
Fig. 3b
-
Take out
fan
motor
housing.
- Remove cotter pin and bolt from yoke.
- Loosen jam screw in yoke until it is flush with the inside surface.
- Obtain downrod, canopy and yoke cover.
- Place downrod inside canopy and yoke cover.
- Route wires exiting motor through yoke cover, canopy and downrod.
Fig. 4c
Fig. 3f
J-Hook
Ceiling
Wood Joist
Outlet Box
Rubber Gasket
Mounting Bracket
Outlet box Screws
(not provided)
Fig. 3g
Canopy
Safety
Cable
Temporary
Hook
J- Hook
Safety
Cable
Fig. 4a
Canopy
Fig. 4b
Hang fan on mounting bracket.
