Pg. #8
Pg. #5
INSTALL MOUNTING BRACKET
2.
Canopy
J-Hook
Ceiling
- Install J-Hook through centre of outlet box and into the wooden joist.
- Secure mounting bracket and rubber gaskets to outlet box.
- Hang the safety cable onto the J-hook.
- Hang fan on mounting bracket.
WARNING: To Reduce The Risk Of Fi re, Electric Shock, Or Personal
Injury, Mount To UL/CSA Listed Outlet Box Marked Acceptable for
Fan Suppo rt And Use Mounting Sc rews Provided With The Outlet Box.
J-
Hook
Safety
Cable
Fig. 3a
Fig. 3b
Outlet box Screws
(not provided)
CAUTION
SEE SAFETY PRECAUTIONS ON
PG. #2 BEFORE WIRING
Green Wire - GROUND
Black Wire (Fan) - POWER
White Wire (Fan) - COMMON
Red or Blue Wire (Light Kit) - POWER
ELECTRICAL HOOK UP
- There are several different wiring combinations that can be used in
controlling your ceiling fan to meet your specific requirements. Should
the following method not meet your requirements call or visit your nearest
distributor for a full list of fan accessories.
3.
-
-
After making the wire connections, ensure the wires should be spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
Ensure the splices after being made should be turned upward and
pushed carefully up into the outlet box.
MOUNT BLADE BRACKETS TO BLADES
Motor Screw
Motor
Lock Washer
Fibre Bracket Gasket
Cast Blade Brackets
- Place blade bracket screw through flat
washer, fibre washer and blade.
- Align with corresponding hole in
blade bracket.
- Repeat with (2) remaining screws
and tighten.
Stamped Blade Brackets
- Place blade bracket screw through
hole in blade bracket.
- Align with corresponding hole in blade
bracket.
- Place fibre washer and flat washer
over blade bracket screw and secure
with hex nut.
- Repeat with (2) remaining screws and
tighten.
MOUNTING BLADES TO MOTOR
-
Take out
hardware
containing
motor
screws,
lock
washers
and
gaskets.
- Place lock washers over motor screws, position motor screws in blade
brackets, place fibre bracket gaskets over screws and secure to motor.
Make sure all screws are tightened securely.
6.
7.
Hex Nut
Blade
Bracket
Blade Bracket
Screw
Fibre Washer
Flat Washer
Lock Washer
Remove Rubber Stops (optional)
NOTE: Fan comes with three rubber stops (optional on some models)
on motor for shipping purposes only. Remove stops before running motor
or installing blades to motor.
Fig. 9a
Fig. 9b
Fig. 8b
Blade Bracket Screw
Fibre Washer
Flat Washer
Blade Bracket
Fig. 8a
Blade Bracket Screw
- Take out hardware package.
- Take out hardware package.
Wood
Joist
Outlet Box
Rubber
Gasket
Mounting
Bracket
