Pg. #3
Pg. #10
1. Wooden Joist
2. Approved (CSA for Canada
and UL for U.S.) ceiling fan box
(not provided)
3. Ceiling
4. J-Hook
5. Rubber Gasket
6. Screws & Lock Washers
(set of 4)
7. Mounting Bracket c/w Ground
Wire
8. Outlet Box Screws (not provided)
9. Rubber Ring (optional)
10. Lock Pin
11. Hemisphere Jam Screw
12. Hemisphere
13. Upper Motor Housing Screws
& Lock Washers (set of 3 or 4)
14. Downrod c/w Ground Wire
15. Ceiling Canopy
16. Rubber Bushing (optional)
17. Bolt
18. Motor Assembly
19. Jam Screws
20. Cotter Pin
21. Nut (optional)
22. Lock Washer (optional)
23. Flat Washer (optional)
24. Hex Nut
32. Blade Bracket Screws
25. Flat Washer
26. Fibre Washer
27. Fibre Bracket Gasket
28. Blade
29. Blade Bracket
30. Lock Washer
31. Motor Screw
With Downrod
Without Downrod
1.
2.
3.
4.
5.
6.
7.
8.
10.
11.
12.
13.
14.
15.
17.
18.
15.
16.
18.
19.
20.
21.
22.
23.
25.
26.
28.
25.
26.
28.
Cast Blade
Brackets
Stamped Blade
Brackets
ASSEMBLY DRAWING
27.
29.
30.
31.
32.
24.
30.
32.
Fig. 1
9.
NOTE: Electrical diagrams are for reference only. Light kits that are not packed with the fan must be CSA/UL
Listed and marked approval for use with the model fan you are installing. Switches must be CSA/UL
General Use witches. Refer to the instructions packaged with the light kits and switches for proper
assembly.
WARNING: Check all connections, set screws and screws are securely tightened
before the next step.
B
PERMANENTLY ATTACHED LIGHT
- Loosen thumb screws on light.
A
DETACHABLE LIGHT KITS
Red or Blue
Wires
Light Kit
Screws
Light Kit
Black Wire
Switch
Housing
White Wires
Lockwasher
White Wire
Screws
Thumb
Screws
Nuts
Chain
Glass Bowl
Lock washer
- Remove 2 clips (optional) and nuts. Loosen third clip (optional) and nut.
Fig.10e
Red or Blue
Wires
Black or
Blue Wires
Red or Blue
Wires
Light Kit
Screws
Light Kit
Black Wire
Switch
Housing
White Wires
Lockwasher
White Wire
Screws
Clips
Chain
Glass
Lock washer
Fig.10f
Red or Blue
Wires
Black or
Blue Wires
Nuts
- Align slots in glass bowl with nipples on
fixture. Slide glass into loosened clip.
Assemble the other 2 clips to the fixture
and then tighten all three nuts in place.
- Connect tassels to switches feeding
chains through nuts on light kit.
NOTE: Pull chain switches are available for some models.
- Loosen thumb screws on light.
- Place shade on light and secure with
thumb screws, finger tight.
- Connect tassels to switches feeding
chains through nuts on light kit.
Fig.10g
- Place shade on light and secure
with thumb screws, finger tight.
Screw
Glass
