Canarm Octa-Lite 8LEC Series
11
5
MOUNTING METHOD 1: UNI-STRUT
5.2 Fasten Unistrut to Roof Structure Mounting Points:
Do not install the fan from a single purlin, truss, or bar joist.
Ne pas installer le ventilateur à partir d’une seule panne, botte, ou solives.
The unistrut must be fastened to the roof structure at each end.
L’Unistrut doit être fixé à la structure du toit à chaque extrémité.
Fasten the unistrut to the roof structure mounting points at each end with customer-supplied Grade 5
hardware as shown.
Fixez l’unistrut aux points de fixation de la structure du toit à chaque extrémité avec le matériel de
qualité 5 fourni par le client, comme illustré.
ATTENTION: Do not tighten the hardware until the upper yoke has been mounted to the unistrut
.
Grade 5 Hardware (customer supplied)
a.
(4) 1/2”-13 GR 5 Bolt
b.
(8) 1/2” Flat Washer
c.
(4) 1/2” Nylock Nut
d.
(4) 2-1/2” Square Washer
b
b
a
d
c
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
(PART NAME HERE)
DRAWN DATE:
XX.XX.XX
DRAWN BY:
XX
PART NUMBER:
XXXX
REV:
_001
THIS DRAWING IS THE EXCLUSIVE PROPERTY OF SKYBLADE FAN COMPANY AND CANNOT BE REPRODUCED OR
DISCLOSED TO ANY THIRD PARTY WITHOUT THE AUTHORIZATION OF SKYBLADE FAN COMPANY
MATERIAL:
XXXXXXXX
ALL DIMENSION ARE IN INCHES
UNLESS OTHERWISE STATED
