10
JETS 2
JETS 1
MENU
JETS
MENU
TEMP UP
JETS 2
JETS 1
MENU
JETS
MENU
TEMP UP
Spa will attempt to “Prime”
itself, press “TEMP UP” to
bypass
Pressing the “TEMP UP”
button or the “TEMP DOWN”
button will cause the current
set temperature to flash
Press the “TEMP UP” or
“TEMP DOWN” button to set
desired temperature while
the numbers are flashing
When the flashing stops, the
temperature is set and will
show the current temperature
of the water
PRESS
TEMP UP
START UP SEQUENCE
Pump 1 will then run on
low speed to read current
temperature. It will then start
to heat up to the set
temperature.
A
B
C
D
E
F
G
H
I
A -
Heat:
Indicates that the heater is on
B -
Ready Mode:
Set temperature will be maintained at all
times (Recommended for Winter months)
C -
Rest Mode:
Heater will only run during filtration cycles
(Recommended for Summer months)
D -
Light:
Multiple colour choices for your custom experience
E -
Cleanup Cycle:
Pump will run 30 min after spa use to filter
and clean spa for 30 min
F -
Jets 1:
Pump 1 is on
Note: longer lines for high speed
G -
Jets 2:
Pump 2 is on
Note: short lines for low speed
H -
Temperature Range
: Temperature can be set between
80°F and 104°F
I -
SET:
Appears when changing settings
J -
Filter Cycle:
Indicates spa is running the filtration cycle
When power is applied to
the spa, the first messages
will be the version number
of the system
Make sure the voltage shown
on your screen matches the
electrical voltage of the hot
tub
(120V
OR
240V)
J
SETTING THE TEMPERATURE
YOUR CONTROL CENTRE
*Only on multi-pump spas
PRESS
TEMP UP
Note: Jets 1 low speed will
continue to run until the set
temp is reached
Note:
TOO COLD message may occur if the initial water is too cold. Pump will continue to run until temperature reaches 45°F at
which point the heater will turn on
PRESS
TEMP UP
--- -
CONTROL CENTRE GUIDE
