ASSEMBLY INSPECTION
rbl2013-002-024
TYPICAL
NOTE:
It can also be done directly on the info-cen-
ter, using the selector button.
Resetting Last Service
1. Click on the RESET SERVICE button to reset
the informations.
vbl2006-007-004
TYPICAL
NOTE:
After each maintenance service, Last Ser-
vice should be reset to keep a good track of vehi-
cle service history.
Setting Units of Display
NOTE:
The speedometer is factory preset in miles
but it is possible to change it to kilometer reading.
Any unit modification is applied to the speedome-
ter, odometer and trip meter.
1. Select the SETTING tab in B.U.D.S.
2. Select CLUSTER page.
3. Select
Metric
or
Imperial
from the
Cluster
Units
section.
NOTE:
No data will be lost when changing this set-
ting.
Ending a B.U.D.S. Session
NOTICE
Clear the fault(s) after a problem has
been solved. This will properly reset the appro-
priate counter(s).
1. Click on FAULT tab and check if there are active
faults. If so, service vehicle then clear the faults
in B.U.D.S.
2. Click on WRITE DATA button to transfer new
settings and information to the modules.
vmr2006-012-100_ben
WRITE DATA BUTTON
3. Click on EXIT button (right most) to end session.
4. Reinstall DCL connector in its holder.
5. Reinstall RH service cover on vehicle.
ASSEMBLY INSPECTION
Inspect the following parts to make sure that the
vehicle is properly assembled.
NOTE:
Ensure that all protective materials are re-
moved from vehicle.
– Front compartment cover and seat locks
– Passenger grab handles
– Front wheel nuts torque (must be 105 N•m
(77 lbf•ft))
– Rear shock absorber retaining nuts torque
(must be 48 N•m (35 lbf•ft))
– Suspension arm ball joint cotter pins
– Tie rod end nuts and cotter pins
– Rear axle nut and cotter pin
– Gearshift pedal operation
– Parking brake operation
– Brake lines
– Foot pegs.
NOTE:
Refer to the Predelivery Check List to con-
firm that all items are covered by your inspection.
50 / 52
2014-1
PREDELIVERY
