Camplux FT30IB, Инструкция по установке и эксплуатации

Страница: 11 / 20

Visit Us: Camplux.com
support@camplux.com
3330-A Marathon Ct Charleston, SC 29418
1(844) 538-7475
10
www.camplux.com
12. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal supply system.
See chapter 5 of the standard for storage and handling of liquefied
petroleum gas, ANS/NFPA 58. Your local library or fire department
should have this book.
Storage of an appliance indoors is permissible only if the cylinder is
disconnected and removed from the appliance. A cylinder must be
stored outdoors in a well-ventilated area out of the reach of children.
A disconnected cylinder must have dust caps tightly installed and
must not be stored in a building, garage or any other enclosed area.
The maximum inlet gas supply pressure: 250 PSI, The minimum inlet
gas supply pressure: 5 PSI.
The minimum hourly of 10000 BTU is required input rating for a heater
for automatic operation at ratings less than full input rating.
The pressure regulator and hose assembly supplied with the appliance
must be used.
The installation must conform with local codes, or in the absence of local codes, with national fuel gas code,
ANS Z223.1/NFPA54, natural gas and propane Installation Code, CSA B149.1, or propane storage and
handling code, B149.2.
Standard 20 lb. tank
(Not included)
● Do not store a spare LP-gas cylinder under or near this appliance;
● Never fill the cylinder beyond 80 percent full;
● Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type
of dust cap on the cylinder valve that is provided with the cylinder valve. Other type of caps or plugs may
result in leakage of propane.
13. A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your cylinder
supplier. Never use a propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in accordance with the specifications for LP gas
cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders, spheres and tubes for
transportation of dangerous goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the heater.
Attach regulator to cylinder. Complete attachment. Install cylinder.
LO
W