Campingaz 400 S, Инструкция по эксплуатации

Страница: 18 / 193

- The control knobs should remain as se
- Open the gas supply (valve or lever on the
relief valve).
- Any gas leaks will be indicated by bubbles.
- Tighten the collars if fitted to stop the leak.
Replace any defective parts. The stove
must not be used until all leaks have been
eliminated.
- Close the valve on the gas cylinder.
Important:
An overall inspection and leaks check must
be carried out at least annually and always
after changing the gas cylinder
F - USE
SAFETY PRECAUTIONS
It's recommended that protective gloves
be worn to handle components which may
be very hot.
Do not use the stove within 20 cm of a wall
or similar surface, or any combustible
object.
Place the stove on a horizontal surface
and never move it while it is in operation.
In the event of a leak (smell of gas), cl
all valves.
Wait until the device has completely
cooled before handling or storing it.
After use, always close the valve on the
relief valve or gas cylinder.
Do not use containers of diameter greater
than 26 cm or less than 16 cm.
Keep young children
appliance, some parts can be very hot.
ATTENTION:
completely unfolded and assembled, even
for the stove function.
GB
The control knobs should remain as se
Open the gas supply (valve or lever on the
Any gas leaks will be indicated by bubbles.
Tighten the collars if fitted to stop the leak.
Replace any defective parts. The stove
must not be used until all leaks have been
Close the valve on the gas cylinder.
An overall inspection and leaks check must
be carried out at least annually and always
after changing the gas cylinder
.
SAFETY PRECAUTIONS
It's recommended that protective gloves
andle components which may
Do not use the stove within 20 cm of a wall
or similar surface, or any combustible
Place the stove on a horizontal surface
and never move it while it is in operation.
In the event of a leak (smell of gas), cl
Wait until the device has completely
cooled before handling or storing it.
After use, always close the valve on the
relief valve or gas cylinder.
Do not use containers of diameter greater
than 26 cm or less than 16 cm.
Keep young children away from the
appliance, some parts can be very hot.
the appliance must be
completely unfolded and assembled, even
for the stove function.
-18-
The control knobs should remain as set ( ).
Open the gas supply (valve or lever on the
Any gas leaks will be indicated by bubbles.
Tighten the collars if fitted to stop the leak.
Replace any defective parts. The stove
must not be used until all leaks have been
Close the valve on the gas cylinder.
An overall inspection and leaks check must
be carried out at least annually and always
It's recommended that protective gloves
andle components which may
Do not use the stove within 20 cm of a wall
or similar surface, or any combustible
Place the stove on a horizontal surface
and never move it while it is in operation.
In the event of a leak (smell of gas), close
Wait until the device has completely
cooled before handling or storing it.
After use, always close the valve on the
Do not use containers of diameter greater
away from the
appliance, some parts can be very hot.
the appliance must be
completely unfolded and assembled, even
The safety lever L located on the side of
the lid must be in the stop position (lever
down) to prevent an
closure of the lid.
In Stove or Grill use, light with the
piezoelectric by positioning the adjusting
knob on the “
When using with the Grill, always check
that there is water in the water tank. Never
operate a grill hotpl
rate
(
knobs are in Grill position ( ) after
lighting.
Never let the Grill operate (adjusting knob
in Grill position) without food for more
than the 2 to 3 minutes preheating on pain
of damage to the special coating.
400 S
When the Grill is in operation, the support
on which the unit is standing can get very
hot. The unit must not be placed on a
combustible surface (plastic, tablecloth,
etc.). It is recommended tha
placed
on a heat
(concrete, stone, brick, directly on the
ground
(earth)). Otherwise, an
incombustible, heat
should be placed between the unit and its
support.
1) STOVE FUNCTION
- If the appliance is p
remove the grill hotplates (models
and
water compartments.
- Turn over and refit the pan supports in the
use
points into the holes provided.
The safety lever L located on the side of
the lid must be in the stop position (lever
down) to prevent an
closure of the lid.
In Stove or Grill use, light with the
piezoelectric by positioning the adjusting
knob on the “
” position.
When using with the Grill, always check
that there is water in the water tank. Never
operate a grill hotpl
rate
). Check that the appliance adjusting
knobs are in Grill position ( ) after
lighting.
Never let the Grill operate (adjusting knob
in Grill position) without food for more
than the 2 to 3 minutes preheating on pain
of damage to the special coating.
400 S and 400 SG models
When the Grill is in operation, the support
on which the unit is standing can get very
hot. The unit must not be placed on a
combustible surface (plastic, tablecloth,
etc.). It is recommended tha
placed
on a heat
(concrete, stone, brick, directly on the
ground
(earth)). Otherwise, an
incombustible, heat
should be placed between the unit and its
support.
1) STOVE FUNCTION
If the appliance is p
remove the grill hotplates (models
and
600 SG ), the pan supports and the
water compartments.
Turn over and refit the pan supports in the
use position by pushing the wire anchor
points into the holes provided.
The safety lever L located on the side of
the lid must be in the stop position (lever
down) to prevent any unintentional
In Stove or Grill use, light with the
piezoelectric by positioning the adjusting
” position.
When using with the Grill, always check
that there is water in the water tank. Never
operate a grill hotplate at maximum flow
). Check that the appliance adjusting
knobs are in Grill position ( ) after
Never let the Grill operate (adjusting knob
in Grill position) without food for more
than the 2 to 3 minutes preheating on pain
of damage to the special coating.
models:
When the Grill is in operation, the support
on which the unit is standing can get very
hot. The unit must not be placed on a
combustible surface (plastic, tablecloth,
etc.). It is recommended that the unit be
placed
on a heat-resistant surface
(concrete, stone, brick, directly on the
ground
(earth)). Otherwise, an
incombustible, heat-insulating material
should be placed between the unit and its
1) STOVE FUNCTION
If the appliance is packaged for transport,
remove the grill hotplates (models
400 SG
), the pan supports and the
water compartments.
Turn over and refit the pan supports in the
position by pushing the wire anchor
points into the holes provided.
L
The safety lever L located on the side of
the lid must be in the stop position (lever
y unintentional
piezoelectric by positioning the adjusting
When using with the Grill, always check
that there is water in the water tank. Never
ate at maximum flow
). Check that the appliance adjusting
knobs are in Grill position ( ) after
Never let the Grill operate (adjusting knob
in Grill position) without food for more
than the 2 to 3 minutes preheating on pain
When the Grill is in operation, the support
on which the unit is standing can get very
hot. The unit must not be placed on a
combustible surface (plastic, tablecloth,
t the unit be
resistant surface
(concrete, stone, brick, directly on the
ground
(earth)). Otherwise, an
insulating material
should be placed between the unit and its
ackaged for transport,
400 SG
), the pan supports and the
Turn over and refit the pan supports in the
position by pushing the wire anchor