Campbell Wind Monitor Series, Инструкция по эксплуатации

Страница: 11 / 38

Wind Monitor Series
3
FIGURE 4-1. Wind monitor mounted to a CM200 Series Crossarm
with pn 17953 NU-RAIL®
4.2 Step 2 — Use SCWin Short Cut to Program Datalogger
and Generate Wiring Diagram
Short Cut is an easy way to program your datalogger to measure this sensor
and assign datalogger wiring terminals. The following procedure shows using
Short Cut to program the sensor.
1. Install Short Cut by clicking on the install file icon. Get the install file
from either www.campbellsci.com , the ResourceDVD, or find it in
installations of
LoggerNet
,
PC200W
,
PC400
, or
RTDAQ
software.
2. The Short Cut installation should place a Short Cut icon on the desktop of
your computer. To open
Short Cut
, click on this icon.
Wind Monitor
pn 17953 NU-RAIL®
Mounting Pipe
(supplied with sensor)
CM200 Series Crossarm