Setting the Battery Packs Charge Level
Setting the Battery Packs Charge Level
The battery charge level must be set before you can use your Allegro.
To do this, complete the following steps:
As MS DOS loads, no action is required until it gets to the
Battery
Change Detected
screen.
The Arrows key will move your selection between the
Battery Charge
Percent
and the
Battery Charge Capacity
.
F1 moves the selected setting up.
F2 moves the selected setting down.
ESC or ENTER exists the
Battery Change Detected
screen and saves
your settings.
Set the charge percent to 10% by pressing on
F1
or
F2
to move the
percent.
The capacity of the NiMH battery we have provided with the
Allegro is 3800 mAh. The capacity default is set at 3800.
If you are using a different brand of NiMH battery pack and are
unsure of your batteries capacity check the label on the battery to
discover the charge capacity. If it is not 3800 mAh you will need to
set the capacity as well.
Press
ESC
or
ENTER
to save your settings and exit the
Battery
Change Detected
screen.
Note: The Battery Change Detected screen closes and the charge status is
set. Once the battery pack is fully charged, the gauging automatically sets to
100%.
The Allegro is now operational but it needs to remain attached to the
AC wall charger until the battery pack is fully charged (approximately
two to three hours).
1)
2)
