Campbell csi mAXON, Инструкция по эксплуатации

Страница: 31 / 74

Section 3. Radiotelemetry Network Components
3-9
3.2.2 Radio Specifications
The RF310 radios are manufactured by Maxon Data Telemetry. See the
Appendix section for radio specifications.
RF310
FIGURE 3-3. RF310 On Bracket With Connector
3.2.3 Radio Installation
The RF310 Radios are shipped from Campbell Scientific mounted on a special
bracket with a cable going from the radio to a BNC connector (see Figure 3-3).
The following steps will install a radio for a field or repeater station. Power
should be off before installing radios.
1. Secure the radio and its bracket to the RF310M using screws from the
RF310M Modem's lid.
2. Connect the 9-pin connector (with the red and black power leads coming
out of it) of the radio/RF modem cable into the radio.
3. Connect the 10-pin connector of the cable into the RF modem.
4. Connect the red and black power leads from the radio cable to the 12V and
Ground.
5. Route the BNC end of the antenna cable through the enclosure conduit.
Connect the cable to the BNC Jack connector secured on the radio
mounting bracket.
3.3 Antennas and Cables
Antennas radiate and receive the radio signals. Each radio in an RF telemetry
system must have an antenna. Coax cable is used to connect the antenna to the
radio.