CS300 and CS301 Pyranometers
7
4. Loosely mount the pyranometer levelling base on the CM225 or 015ARM.
Do not fully tighten the three mounting screws.
5. Turn the levelling screws as required to bring the bubble of the bubble
level within the ring.
6. Tighten the mounting screws to secure the assembly in its final position.
Check that the pyranometer is still correctly levelled and adjust as
necessary.
7. Route the sensor cable along the underside of the crossarm or 015ARM
mounting arm to the tripod/tower, and to the instrument enclosure.
8. Secure the cable to the crossarm or 015ARM mounting arm and mast by
using cable ties.
9. Remove the green cap after installing the sensor. Save this cap for
shipping or storing the sensor.
Mounting holes used for
the CS300 and CS301
are indicated in yellow.
CS300 or CS301
Pyranometer Levelling Base