1
CS120A Power Supply Enclosure
Important Safety Instructions – please request a translation or further advice if you cannot
understand this document.
Wichtige Sicherheitshinweise - bitte kontaktieren Sie uns bzgl. einer Übersetzung falls Sie
Schwierigkeiten haben Inhalte dieses Dokumentes zu verstehen.
Consignes de sécurité importantes - N'hésitez pas à demander un avis ou une traduction, si vous
ne pouvez pas comprendre ce document
Instrucciones de Seguridad Importantes – solicite por favor traducción o asesoramiento
adicional si no entiende este documento.
Istruzioni di sicurezza importanti - chieda prego una traduzione o avanti il consiglio se non
potete capire questo documento.
Instruções de segurança importantes - por favor, solicitar uma tradução ou conselho mais se
você não consegue entender este documento.
1.
Installation instructions for an enclosure that
includes a mains powered CS120A Power Supply
This document is supplied with an enclosure that includes a CS120A power supply
enclosure as it requires direct wiring of an AC, mains power source to terminals
inside this enclosure. The instructions below describe how to do this and
precautions for the use of the system after installation.
The CS120A power supply is sold as a kit that is normally fitted inside a standard
Campbell Scientific environmental enclosure often with other components such as
a datalogger or communications interfaces. The layout of each enclosure can
therefore vary, but the wiring details for the AC supply are standard. The power
supply is sized to have the capacity to power the CS120A with its hoods heaters on
and to charge one of Campbell Scientifics standard rechargeable power supplies,
e.g. the PS100 or PS200 supplies.
1.1 Required knowledge
The wiring of the enclosure should only be carried out by personnel qualified to
install electrical equipment relevant to the installation. For permanent
installations outside this usually requires a certified electrician who is also familiar
with local electrical and safety legislation. Some general guidance is given below,
but the responsibility for the installation lies with that installer.
1.2 Preparation and initial checks
Choice of site: unless otherwise stated, the enclosure supplied is designed
to be mounted in an area with restricted access, i.e. not accessible to
general public where it might be vandalised. If access is not restricted
please contact Campbell Scientific for further advice.
