Campbell CD295, Руководство по эксплуатации продукта

Страница: 20 / 32

DataView II (CD295) Dual Line Display
18
3. Apply a thin coating of neutral-cure silicon sealant between the flange of
the CD295 and enclosure door.
4. Use the screws and nuts provided to attach the CD295. Insert the head of
the screw followed by a flat washer through the front of the CD295. On
the inside of the enclosure, fit the rubber O-ring washer then the second
flat washer followed by the dome nut.
5. If fitted, remove the nut, bolt and washers from the top-left mounting hole
of the CD295 front panel.
6. Remove the “nylock” nut, stainless steel and rubber washers from the bolt
assembly fixed to the CD295 door. At this point, the bolt assembly holding
tag should be exposed.
7. Insert the bolt assembly through the top-left mounting hole of the CD295
front panel
8. From the inside of the enclosure, fit the rubber washer, stainless steel
washer and “nylock” nut onto the stainless steel bolt assembly.
9. After confirming that all hardware has been fitted in the correct order, tear
off the “Bolt Assembly Holding Tag”.
10. Tighten the “nylock” nut until the black rubber washer is tightly
compressed.
If you are fitting the CD295 door kit, only three bolts are required
to be fitted at this step. The bolt in the top-left corner of the CD295
front panel is not required . In this case, only fit the remaining
three bolts, and use the longer (25 mm) bolt supplied in the door
kit in the top-left hole. Do not over tighten as this will cause
damage to rubber washer.
See Appendix A , CD295 Door Kit Assembly Diagram
(p. A-1)
, for the assembly
diagram for the CD295 door kit.
NOTE