8
Glossary
Become familiar with these terms before operating the unit.
ACTUATE (TOOL) —
To cause movement to the tool’s component(s) intended to
drive the fastener.
ACTUATION SYSTEM —
The use of a trigger, work contact element (WCE) and/
or other operating control, separately or in combination or sequence, to actuate
the tool.
AIR INLET —
The opening in which the compressed air supply is connected,
usually by means of a threaded fitting.
FASTENERS —
The nailer uses fasteners ranging from 2 inches to 3-1/2 inches
long, from 0.113 inch to 0.131 inch in shank diameter, and from 30° to 34°.
MAGAzINE —
The part of the nailer that holds the Fasteners.
MAxIMUM AIR PRESSURE —
The maximum allowable pressure of compressed
air, as specified by the manufacture, for operating the tool.
NO-MAR DECKING TIP
— The no-mar decking tip is designed to eliminate
marks caused by the serrated Work Contact Element (WCE). The no-mar tip may
be removed and tethered to the tool if not required (See REMOVING NO-MAR
DECKING TIP) or when a slightly deeper countersink is preferred. Simply slide
the no-mar off the WCE and attach to the retainer on the magazine. Use tool in
single cycle mode (SEE OPERATIONAL MODES) when no-mar tip is in place (
see
Figure 5
).
psi (POUNDS PER SqUARE INCH)
—Measurement of the pressure exerted by
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
qUICK COUPLER —
A
quick coupler is designed to work in combination with a
quick plug to quickly and easily join a pneumatic tool to an air hose (
see Figure 3
).
qUICK PLUG —
A quick plug is designed to work in combination with a quick
coupler to quickly and easily join a pneumatic tool to an air hose (
see Figure 4
).
REGULATOR —
A device used to control air pressure to an air operated tool
THREAD LOCK GLUE
— A locking glue that is applied to the screw threads
before installing. Prevents the screws from working loose during tool operation.
Figure 3 - Quick Coupler
Figure 4 - Quick Plug
Figure 5 - No-mar decking tip
www.chpower.com
CHN70800
Operating Instructions and Parts Manual
