![background image](http://html1.mh-extra.com/html/campbell-hausfeld/in704700av/in704700av_operating-instructions-manual_489843006.webp)
6
Operating Instructions
NB006401
www.chpower.com
User - Maintenance
Instructions
CLEARING A JAM FROM THE TOOL
1. Disconnect the air
supply from the
tool.
2. Remove all nails
from the magazine
(see Loading/
Unloading). Failure
to do so will cause
the nails to eject
from the front of the tool.
3. Undo hook by
pushing down on
the buttons on
the sides of the
magazine. The
buttons will disengage the hook
from the nose.
4. The door can
now be rotated,
exposing the
jammed fastener.
5. Remove the
jammed fastener,
using pliers or
a screwdriver if
required.
6. Rotate door back into the closed
position.
7. Push buttons down again to lift the
hook. Close the door and release the
buttons to reengage the hook with
the nose.
8. Make sure the
trigger and work
contact element
(WCE) move freely
up and down
without sticking or binding.
TECHNICAL SERvICE
Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this tool or
for additional copies of this manual.
FASTENER AND REPLACEMENT
PARTS
Use only headless
micropins, 16 gauge.
Tool performance, safety and durability
could be reduced if improper fasteners
are used. When ordering replacement
parts or fasteners, specify by part
number.
TOOL REPAIR
Only qualified personnel should repair
the tool and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently.
ASSEMBLY PROCEDURE FOR SEALS
When repairing a tool, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W
non-detergent oil or equivalent, must
be added through the air line before
testing.
STORAGE
The tool should be stored in a cool dry
place.
Fasteners
The following Campbell Hausfeld finishing nails are available at local retail stores.
If you need help locating any item, call customer service at 1-800-543-6400.
Campbell Hausfeld nails meet or exceed ASTM Standard F1667.
Model
Length
Shank
Gauge
Finish
Head
Collation
Nails
Per
Stick
Nails
Per
Box
FB005060
2
inch
16
Gauge
Galvanized
Brad
Adhesive
50
2500
FB160025
1
inch
16
Gauge
Galvanized
Brad
Adhesive
50
1000
FB160040
1-1/2
inch
16
Gauge
Galvanized
Brad
Adhesive
50
1000
FB160050
2
inch
16
Gauge
Galvanized
Brad
Adhesive
50
1000
FB160065
2-1/2
inch
16
Gauge
Galvanized
Brad
Adhesive
50
1000
Interchange Information
Nails used in the Campbell Hausfeld NB006401 Finishing Nailer will also work in
Hitachi NT65A, Paslode 3250-F16, IM250F, Duo Fast LFN-764, Sears 18321, Porter
Cable FN200 and FN250.