FT-277 Rittenhouse Fountain
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 435 pounds with an approximate 4.5 square foot footprint.
FT-277F (178 lbs)
30”L x 30”W x 8.5”H
FT-277D (22 lbs)
8.5”L x 8.5”W x 7.5”H
FT-277C (31 lbs)
7”L x 7”W x 9”H
FT-277B (28 lbs)
15.5”W x 28”H
FT-277A (2 lbs)
6.75”W x 1”H
FT-277E (3 lbs)
4”L x 1”W x 5”H
1. Place the basin (FT-277F) into position where the fountain will be installed,
ensuring that it is level.
2. Assemble the pump kit
a.
Connect the tubing to the pump outlet.
b. Place the stopper around the pump cord approximately 8 inches from the pump.
3. Feed the pump cord through the hole in the basin (FT-277F) and the channel.
4. FIRMLY press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best to press the
stopper in place.
5. Place the pump house (FT-277D) over the pump and in the center of the basin
(FT-277F).
6. Center the pedestal (FT-277C) over the pump house (FT-277D).
7. Feed the tubing connected to the pump through the hole in the center of the
pedestal (FT-277C).
8. Center the bowl (FT-277B) over the pedestal (FT-277C).
9. Use a hose clamp to secure the tubing to the pipe protruding from the bottom of
the bowl (FT-277B).
10. Use the silicone provided to attach the copper spillers
a. Clean away any excess silicone.
11. Place the water control disc (FT-277A) into the bowl (FT-277B).
12. Fit the pump house door (FT-277E) into the pump house (FT-277D).
13. Let the fountain sit 24 hours before filling with water.
uniquegardendecor.com
(866) 382-8600
