FT-337 M Weave Disc Fountain
Revised August 15, 2019
Assemble your fountain on a level surface capable of holding a minimum of 225 pounds with
an approximate 1.5 square foot footprint.
FT-337B (176 lbs)
21.75”W x 22”H
Light / Spout
FT-337A (13 lbs)
16.75”W x 1”H
Transformer
1.
Position the basin (FT-337B) where the fountain is to be
installed, ensuring that it is level.
2.
Place the O-Ring around the
Light / Spout.
a.
The O-Ring will secure the
Light / Spout
in place and
allow for the water to flow
correctly in the fountain.
(
IMAGE
RIGHT
)
3.
Attach the non-kink tubing to the
Light / Spout.
4.
Feed the
Light / Spout
cord and non-kink tubing through the
hole in the top of the water feature disc (FT-337A).
5.
Carefully press the
Light / Spout with O-Ring
into the hole at
the top of the hole in the disc.
a.
Note: Use a flathead screwdriver or similar tool to press
the O-Ring deeper into the hole around the
Light /
Spout
.
6.
Attach the
Pump
to the non-kink tubing with a hose clamp.
7.
Feed both cords through the PVC pipe in the basin (FT-337B)
and out of the channel underneath.
a.
Note: Be sure to place one plug below the other. If you
try forcing both plugs through at the same time, they
will not fit.
8.
Place the stopper around the pump cord and light cord.
9.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer
works best to press the stopper in place.
10.
Place the water feature disc (FT-337A) into the top-center of
the basin (FT-337B).
11.
Connect the
Light / Spout
to the LED-Cord then the
Transformer.
12.
Fill the basin with water.
