FT-320 Large M Weave Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 1200 lbs with an
approximate 6 sq. ft. footprint (actual dimensions 38" x 25").
Step 1 - Place the basin (FT-320E) where the fountain is to be installed, ensuring that it is level.
1a - Note: Be sure the drain hole is positioned toward the front of the basin.
FT-320E (468 lbs)
38"L x 25"W x 16"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
FT-320C (64 lbs)
33.5"L x 6.25"W x 8.25"H
FT-320A (561 lbs)
133"L x 7.75"W x 33.5"H
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the non-kink end of the tubing assembly to the
pump outlet.
Step 3 - Install the #7 Drain Stopper into the drain hole.
Step 4 - Center the pump cover (FT-320C) along the back wall of the basin (FT-320E).
Step 5 - Place the pump in the center of the pump cover (FT-320C).
Step 6 - Lay the pump cord over the edge at the back of the basin.
6a - Note: There is a cut out in the back of the water feature (FT-320A) that will
accomodate the cord.
Step7 - Place the water feature (FT-320A) on top of the pump cover and ensure that the pump cord
exits through the hole provided.
Step 8 - Insert the CPVC pipe attached to the pre-assembled tubing into the coupling protruding
from the bottom of the water feature (FT-320A).
