FT-286 Falling Water I Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 500 lbs with an
approximate 3 sq. ft. footprint (actual dimensions 22.5" x 15").
Step 1 - Position the base (FT-286E) where the fountain is to be installed, ensuring that it is level.
FT-286E (140 lbs)
22.25"L X 15"W x 15"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 2 - Position the basin (FT-286F) over the base (FT-286E).
FT-286F (162 lbs)
30"L X 20.25"W x 9"H
Step 3 - Place the pump cover (FT-286C) along the back edge of the basin.
Step 4 - Assemble the pump and tubing:
4a - Using a hose clamp, attach the 1/2" non-kink tubing to the small pump outlet.
Step 5 - Place the pump in the center of the pump cover (FT-286C).
Step 6 - Lay the pump cord over the edge at the back of the basin (FT-286F).
FT-286C (20 lbs)
21"L X 6.75"W x 6.75"H
