FT-218 St. Aubin Wall Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 950 lbs with an
approximate 6 sq. ft. footprint (actual dimensions 38" x 22").
Step 1 - Position the basin (FT-218A) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump and tubing:
2a - Using a hose clamp, attach the non-kink tubing to the pump outlet.
2b - Place the stopper around the pump cord approximately 6 inches from the pump.
Step 3 - Feed the pump cord through the hole in the back wall of the basin (FT-218A).
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 5 - Attach the other 5/8" clear end of the tubing assembly over pipe protruding at the bottom
of the basin (FT-218A).
Step 6 - Place the #7 drain stopper into the hole in the back right corner on the floor of the basin.
FT-218A (737 lbs)
40"L x 22"W x 41"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 7 - Place the pump cover (FT-218B) over the pump.
Step 8 - Fill the fountain with water.
FT-218B (29 lbs)
11"L x 8.5"W x 8"H