GFRCFT-1111 Bilbao Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 250 lbs with an approximate 3ft. square
footprint (actual dimensions 31.5" x 31.5").
Step 1 - Make sure you are assembling your fountain on a level surface.
Step 2 - Unpack the provided pump.
NOTE – Be sure to use the appropriate size adapter provided with the pump.
Step 3 - Place the pump in the center of the basin
NOTE – Keep 18” of the pump cord in the basin with the pump for easier installation. The remainder of the cord
will drape over the back center of the basin.
Step 4 - Place the base over the basin with the access door at the back of the fountain. The basin should touch the inside wall
of the base, which will allow enough space to access to the pump.
Step 5 - Run the pump cord through the channel that is cut into the bottom of the base.
Step 6 - Protect the top of the base with a towel, piece of cardboard, or something similar that will not scratch the surface of
the base.
Step 7 - Rest the jar on the base.
Step 8 - Hook the pump to the tubing that comes attached to the jar.
Step 9 - Move the pump towards any edge of the basin until it is not visible from the top. This will allow the jar to fit securely
into the hole.
Step 10 - Set the jar into place on the base.
NOTE – Do not allow pump to run dry, as it will cause damage to the pump.
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
