CRANKSET - Rev. 04/ 06-2022
CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
9
After installing the bottom bracket cups specific for your Ultra-Torque crankset in the bottom bracket shell (to understand the exact compatibility,
refer to the “Bottom bracket cup” chapter of the technical manual).
• Insert the right hand crank fully down in the bottom
bracket shell (fig. 1)
.
• Push the spring to make the two ends enter in the small
holes (fig. 2).
• Move the right hand crank to the side as if to extract it
from the bottom bracket, to ensure that the spring was
positioned correctly and is retaining the hand crank (Fig. 3)
• Insert the wave washer (Fig.4 ) in the space for the left
bottom bracket cup bearing.
• Insert the left hand crank in the bottom bracket shell.
WARNING!
Use the special screw (code FC-SR007 (for SR crankset) - FC-RE007 (for the other cranksets)). The use of a different screw could be the cause
of malfunction or breakage, accidents, physical injury or even death.
1
2
3
4
5
65 mm MIN.
• Using the Campagnolo
®
UT-BB110 tool or a suitable 10
mm hexagonal insert with a length of at least 65 mm,
engage the fastening screw (Fig. 5) in the semiaxle of the
right-hand hand crank until it goes through the hole at the
inner end of the semiaxle itself. Then engage the thread of
the semiaxle of the left-hand hand crank.
• Using the Campagnolo
®
UT-BB110 tool or a suitable 10
mm hexagonal insert with a length of at least 65 mm,
engage the fastening screw (Fig. 5) in the semiaxle of the
left-hand hand crank until it goes through the hole at the
inner end of the semiaxle itself. Then engage the thread of
the semiaxle of the right-hand hand crank.
4 - ASSEMBLY
