Page 50
Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 11/04/2022
ADJUSTMENT OF THE DEPTH LIMITERS
Place the depth gauge on the chain (1), so that the depth limiter is protrud-
ing. File the protruding part of the depth limiter with a flat file until the same
level as the depth gauge is achieved. Round the front angle of the depth
limiter.
6.1.6 End of work maintenance
•
Follow all the maintenance and cleaning instructions in the manual.
•
Empty the oil tank (18) and close the cap (19).
•
Remove cutting residues (sawdust) under the rear cover (5). Reassemble and clean the tool perfectly.
•
Insert the bar cover (20) on the cutting bar.
CAUTION!
Remove the front casing (5) periodically and eliminate any cutting residues which might prevent the tool from
working perfectly.
6.2 Troubleshooting
Type of alarm
Number of flashes
on the display
Number of beeps
Type of error indi-
cated on the dis-
play
No problem
0
0
E00
Contact protection
1
1
E01
Current sensor error
2
6
E02
Damage to MOSFETs
3
6
E03
Overcurrent / medium current peak protection
5
5
E05
Pruner blocked / motor blocked
6
3
E06
Phase loss
7
4
E07
Undervoltage / overvoltage
8
1
E08
MOSFET overheating
9
6
E09
EEPROM error
11
6
E11
Phase detection error
12
4
E12
Programming error
13
6
E13
The motherboard failed to communicate with the bat-
tery pack
17
10
E17
6.3 Extraordinary maintenance
CAUTION!
Any extraordinary maintenance work must be performed at a Service Centre authorised by the Manufacturer.
The workshop authorised to carry out repairs on the Manufacturer’s products.
AUTHORISED WORKSHOP