CAMPAGNOLA PUMA, Руководство по эксплуатации и обслуживанию

Страница: 45 / 72

ATTENTION!
• Any other use has to be considered improper and potentially dangerous for the operators‟ safety. This would make any
warranty claims void.
• If it is not used for the purposes it was designed for, the tool may cause serious injuries to personnel and bystanders and
damages to equipment and things.
3.5 Tool parts
POS. DESCRIPTION FUNCTION
PICTURE
REFERENCE
1 Handle Permits to hold the tool A
2 Front guard Protects the pinion and the bar chain A
3 Bar guard
Protects the chain when the tool is not being used
A
4 ON/OFF switch Switches the tool on and off B
5
Operating lever Operates the tool when it is being pressed
B
6
Safety device Controls the operating lever
B
7 Handle connector Connects the tool to the power supply cable B
8
Holding handle Allows the operator to work holding the tool
C
9
Tap Allows to add oil to the reservoir
C
10 Led light Shows whether the tool is on or off C
11
Power supply cable Connects the tool to the battery
D
12
Inertial chain brake (only tool
model without extension pole) Protects the hand and operates the emergency brake
E
13
Locking nut Locks the bar
E
14
Bar Drives the cutting chain
F
15
Chain Cuts branches, trunks, etc.
F
16
Adjustment screw Adjusts the chain tension
F
17
Motor housing Contains the motor and the flexible circuit boards
F
18
Chain locking pin Stops the chain in case of breakage
F
19 Identification sticker Shows the product identification details N
20 Lubrication pump flexible
circuit board Operates the lubrication pump O
21 Lubrication pump Lubricates the bar and the chain O
22 Lubricating oil reservoir Contains the oil for the bar and chain lubrication O
23 Flexible circuit board Drives the tool O
24 Brushless motor Gives motion to the chain O
3.5.1 Parts of the extension-pole connected model
25 Fixed extension pole Holds the tool and makes working from the ground easier V
26 Telescopic extension pole Holds the tool and makes working from the ground easier Z
27 Branch-pulling hook Helps the operator to clean the cutting area X
28 Cable protection Protects the cable from twisting and tugs W
3.6 Specifications of the tool with direct handle
• Chain pruner weight with 8‟‟ bar: 1.800 kg
• Cutting bar (14) length: 8”
• 8” bar (14) max. cut : Ø 150 mm
• Inertial chain brake (12): Yes
• Active safety device (6): Yes
• Automatic chain (14) lubrication: Yes
• Min. and max. tension limit of the lead battery: 9V – 14V
• Min. and max. tension limit of the lithium battery: 11.5V – 18.5V