Page 6
INSTALLATION AND MOUNTING
4
- Remove the mounting bracket from the heater – loosen the locking screw if necessary.
- Respect all minimum clearances (page 5 Fig. A).
- Position the bracket on the wall, making sure it is properly oriented and that the bottom
fastening holes are at a height of 32 cm (12 1/2 in.) from the floor.
- On some models, the bracket may not be centered on the heater. Use the center refe-
rence mark on the bracket to position it.
- Check that the bracket is leveled and mark the 6 fixing holes.
- Install the appropriate wall anchors and fasten the mounting bracket with 6 screws.
Maximum screw size : 5,5mm (7/32 in.).
Floor level
When inserting the programming module or interface
(optional), we recommend leaving a 300 mm(12 in.) gap
between the corner of the wall and the heater to take the
receiver cover.
Center Label
32 cm (12 1/2”)
F
IG
. B
CAUTION
Because of the heavy weight of this heater, particular care must be taken when handling and installing it. Use
screws and anchors adapted to the wall type and weight of the heater.
