Camozzi F Series, Инструкция по использованию и обслуживанию

Страница: 21 / 85

Use and maintenance instruction
Valves series F
93-7507-0014
Revision B
It is recommended that every safety rule associated with the product is strictly adhered to.
Do not interfere with the machine or appliance without first checking that the working conditions
are safe.
Before installing the product or beginning a maintenance procedure first ensure that any lock-out
controls are safely activated. The power supply should then be removed (if necessary) along with
the pressure supply system before exhausting all residual compressed air in the system. Next drain
any residual energy stored in springs, capacitors, reservoirs or vessels. Be aware of any machinery
movement due to gravity when the air is removed from the system.
After product installation or maintenance, reconnect the supply pressure and power (if necessary)
and check that the product is functioning correctly. If a leak is found or the product is not
functioning correctly then it should not be put into operation.
The product should only be put into operation if all of the Camozzi defined specifications and
criteria are met. If they are not met, the product should only be put into operation after receiving
approval from Camozzi.
To reduce the noise caused by air being discharged from the component, use appropriate silencers
or direct the fluid into an area where, during normal operation, there are no employees present .
When designing the pneumatic circuit, limit the number of removable connections as much as
possible. Use flexible pipes of the correct length to reduce any potential mechanical stresses.
If the system is not equipped with soft start valves, sudden pressures could exist during start up
that could cause cylinder pistons rods to move. Make sure that these cylinders are in their end
position and that they do not cause any potential hazard.
Avoid covering the equipment with paint or other substances which could reduce its thermal
dissipation.