Camozzi CX06 Series, Инструкция по эксплуатации и обслуживанию

Страница: 24 / 27

Operation and maintenance instructions
CPU PROFINET Series CX06 module
5000004825
Versione 01
52
settings, exit the software CX-Configurator , remove the USB cable and re-fit the transparent
panel to restore the specified IP protection rating.

On start-up of the software CX-Configurator the system verifies communication between
the device and the PC where the configuration software is installed. In the event of
communication failure, an error message is displayed.
Type of fault Causes Remedy
Communication
failure between
CPU module
and PC
Electrical
power
supply not
connected
Connect the Electrical power supply by means of the M12
connector POWER.
USB cable
not
connected
Connect the USB cable to one of the ports available on the PC
and to the Micro USB connector under the transparent panel
on the device.
USB drivers
not installed Contact the Camozzi technical assistance service.
8. Use

Ensure that the electrical power supply and all other operating conditions remain within the
admissible values.

The product may only be used in observance of the specifications provided; if these
requirements are not met, the product may only be used on authorization by Camozzi.

Observe the specifications on the identification data plate.
9. Troubleshooting and/or exceptional circumstances

The following is the meaning of the LEDs on the top panel of the CPU Unit:
Led 3 (SF) Led 4 (BF)
OFF
No errors No errors
Fixed
Watchdog Timeout; channel diagnostics
message, generic or extended; system
error No configuration present; or low speed
in the physical connection or no physical
connection