●
Replace with a fuse of the same amperage. If the
fuse blow again, consult installation shop where
you purchased it from.
●
Consult installation shop where you purchased it
from.
●
Fuse is blown
●
Incorrect wiring
Power does not turn on. (No sound is produced)
Power it off and power it on again. If it is not working,
consult installation shop where you purchased it from.
The microprocessor has
malfunctioned due to noise,
etc.
Nothing happens when buttons are pressed. Display is not accurate.
●
When direct rays of the sun fall on the light-
receptive part of the remote controller, it may not
work.
●
Check the battery of the remote controller unit.
●
Direct rays of the sun fall
on the light-receptive part
of the remote controller
●
The battery of the remote
controller unit is dead or
there is no battery in the
remote controller unit
The Remote controller does not work.
Check the parking brake is applied.
The parking brake is not
pulled or the parking brake
wire is not connected.
Warning screen is displayed.
●
Adjust the brightness properly.
●
The temperature inside the vehicle may be 0
degree or less. Set to an appropriate temperature
(25 degree or so) and check it again.
●
The display is may dark at night to prevent the
glare (When the headlight of the vehicle is lit in the
daytime, the display gets dark).
●
The brightness control
is too low.
●
The operating condition
is not good.
●
The headlight of the
vehicle is lit.
The display is dark.
Check that Contrast and Color are adjusted properly.
The color is not adjusted
adequately
The color of the display is light or a shade of color is not good.
Set the NTSC / PAL properly according to video
source.
Improper NTSC / PAL
setting.
When video source is connected, the image is disturbed.
GENERAL
MONITOR