12
CampSat Single/Twin
Install Tools and Materials
The antenna system is designed for simple installation and setup.
However, the following list of equipment or items should be available
during installation of the antenna:Electric drill and drill bits
• Socket wrench
• Silicon sealant
• Fastener suitable for specific application
Verification of the Vessel’s Power Supply.
• Confirm that the vessel’s power supply is 12V DC 5A.
1. NOTE:
Look for a sufficiently charged battery when you align the
antenna. Loading procedures can result in abnormal alignment.
Be guaranteed for operation over the 230V/12V board voltage or
power supply unit must be an output of 12V/5A.
2. Verification of the set-top-box and IDU’s attachment and the
electricity supply
Attach Satellite Receiver and IDU in the interior
of the vessel or the trunk. Connect the power of Satellite Receiver
and IDU.Once the power of Satellite Receiver and IDU is verified, it
confirms that both Satellite Receiver and IDU are working normally.
3. Handling of the fastening and installation.
Attach the satellite on
the flat surface area of the vessel’s roof.Connect each end of
the coaxial antenna cable to the satellite’s terminal and the IDU.
Connect the IDU and the Satellite Receiver box together through
the coaxial cable. Make sure that the satellite is working normally,
once the power is supplied.
Preparing for Installation
Warning : Things to consider when installing the antenna:
• Turn off the power when attaching or detaching the antenna.
• Make sure that the attached satellite is fixed on the flat surface.
• When attaching, ensure that all the products are adhered properly.
• Insure that all the cables are connected properly.
Preparing for Installation
