7
DMX
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
MAIN SCREEN STAND-ALONE MODE
Mode Static
is shown on the display.
MAIN SCREEN 1 SLAVE MODE
Mode Slave
is shown on the display.
MAIN SCREEN 2 W-DMX STATUS
The W-DMX status is shown on the display. Briefly press ENTER and DOWN at the same time to switch between the two main displays.
The main display 1 is automatically displayed again after approx. one minute.
W-DMX™
To pair the W-DMX receiver with a W-DMX-enabled transmitter, W-DMX (W-DMX On) must be switched on in the receiver menu under
Wireless Settings
and
Reset
must be selected in the same menu option (select Reset and press ENTER to confirm). The receiver is now
ready to pair and waits for a transmitter to request pairing. Start pairing by selecting
Link
in the transmitter menu and then confirm your
selection. Pairing will then be carried out automatically. These same steps can be used to pair several receivers to a transmitter at the same
time or in succession. A W-DMX connection will remain connected until it is severed by selecting
Reset
in the receiver menu or
Unlink
in
the transmitter menu, regardless of whether a device is temporarily disconnected from the power supply.
W-DMX™ STATUS
RF SIGNAL STRENGTH
W-DMX
deactivated
W-DMX
activated,
not paired
W-DMX
activated
and
paired,
Transmitter
switched off
or out of
range
W-DMX
activated
and
paired,
no
DMX signal
W-DMX
activated
and
paired,
DMX signal
present
CONFIGURING DMX MODE
You can access the main menu by pressing MENU. Using UP and DOWN, now select the
DMX Address
menu option and press ENTER to confirm your selection. You can now set the DMX start address as desired using UP and
DOWN. Select ENTER to confirm your entry.
