CAME T6N, Руководство пользователя

Страница: 48 / 112

P
age
20
- Manual
FA01732-EN
- 07/2022 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
DIP-switch 4 ON Hold-to-run
With the function active, the operator stops moving (opening or closing) when the control device
is released.
When the function is active, it excludes all other control devices, input 2-7 and AF
card operation.
DIP-switch 5 ON Pre-fl ashing
Use this function to activate the fl ashing beacon 5 seconds before any manoeuvre.
DIP-switch 6 ON Obstacle with motor stopped
With the function active, the gate remains idle if the safety devices detect an obstacle.
Input C1
Associate a function with input C1.
If the devices are not connected to the 2-C1 terminal, set DIP switch 7 to ON.
DIP-switch 7 OFF
DIP-switch 14 OFF C1
Reopen while closing (photocells).
DIP-switch 7 OFF
DIP 14 ON C1 = r7
Reopen while closing (sensitive edges with 8K2 resistor).
The safety devices test does not detect this input.
CX input
Associate a function with the CX input.
If the devices are not connected to the 2-CX terminal, set DIP switch 8 to ON.
DIP 8 OFF
DIP 9 OFF
DIP-switch 15 OFF CX = C2
Reclose while opening (Photocells)
DIP 8 OFF
DIP 9 OFF
DIP 15 ON CX = r7
Reopen while closing (sensitive edges with 8K2 resistor).
The safety devices test does not detect this input.
DIP 8 OFF
DIP 9 ON
DIP-switch 15 OFF CX = C3
Partial stop (Photocells)
DIP 8 OFF
DIP 9 ON
DIP 15 ON CX = r8
Reclose while opening (sensitive edges with 8K2 resistor).
The safety devices test does not detect this input.
DIP 10 ON Total stop
Deactivate input 2-1. If DIP switch 10 is set to OFF, the input is used as a normally closed
contact.
With the input open, this function excludes all commands, including any automatic
closing.