CAME FUTURAKITVC04, Руководство по установке

Страница: 11 / 32

SW3
PR
OG
RESE
T
PROG
>8’’
<11’’
a
SW3
PR
OG
RESE
T
PROG
M1
BOUT
SW3
PR
OG
RESE
T
PROG
M2



3 beep
<1’’
M1
BOUT
SW3
PR
OG
RESE
T
PROG
M2
M1
BOUT
SW3
PR
OG
RESE
T
PROG
M2
a

Pa
ge
11
- M
an
ua
l F
B0
095
4-
EN
- v
er
s.
1 - 1
0/
20
17
- © C
am
e S
.p
.A
. - T
he c
ont
ent
s o
f t
hi
s m
an
ua
l m
ay b
e c
ha
ng
ed
, a
t a
ny t
im
e, a
nd w
ith
ou
t n
ot
ic
e.
Programming an intercom group
y
Programming of the intercom group must only take place AFTER assigning a call button to all the extensions.
With the jumper SW3 connected, press the PROG button for at least 8 seconds and
release it (within 11 seconds)
a
as soon as the PROG LED flashes and the backlighting
on the buttons comes on as shown in figure

.
To enable the intercom function, go to the internal extension that you want to program
and press the call button to be used to intercom call it: an acoustic signal will confirm
the programming

. Continue by repeating the same operations for all the other in-
ternal extensions to be included in the intercom group. At the end, briefly press the
PROG button

.
N.B. If no action is performed, the procedure will automatically end after 30
minutes.
y
Once an internal extension has been included in an intercom group through
the assignment of a call button, it can no longer be excluded from the group. If
you want to change the call button for an internal extension that is already pro-
grammed as intercommunicating or add new internal extensions to the group,
simply repeat the sequence of steps described for “Programming an intercom
group”.
Disabling the intercom function
To deactivate the intercom function, you simply have to disconnect the SW3 jumper
a
;
by doing this, programming of the intercom system is also inhibited.
To re-activate this same function, simply re-insert the SW3 jumper

.