CAME FUTURAKITVC04, Руководство по установке

Страница: 10 / 32


SW3
PR
OG
RESE
T
PROG
<1’’

 SW3
PR
OG
RESE
T
PROG
SW3
PR
OG
RESE
T
PROG
<1’’
M1
BOUT
PR
OG
M2
SW3
PR
OG
RESE
T
PROG
>3’’
<6’’

SW3
PR
OG
RESE
T
PROG
>3’’
<6’’
a



beep
SW3
PR
OG
RESE
T
PROG

M1
BOUT
PR
OG
M2

Pa
ge
10
- M
an
ua
l F
B0
095
4-
EN
- v
er
s.
1 - 1
0/
20
17
- © C
am
e S
.p
.A
. - T
he c
ont
ent
s o
f t
hi
s m
an
ua
l m
ay b
e c
ha
ng
ed
, a
t a
ny t
im
e, a
nd w
ith
ou
t n
ot
ic
e.
Exiting programming.
Briefly press the PROG button: the PROG LED goes off.
N.B. If no action is performed, the procedure will automatically end after 30 minutes.
Reprogramming procedure
Accessing programming. Press the PROG button
a
for at least 3 seconds and re-
lease it (within 6 seconds) as soon as the PROG LED flashes and the backlighting on the
buttons comes on as shown in figure

. If the PROG LED does not come on, this shows
a fault. Check the connections and go back to programming.
Programming the call keys.
Press the door lock release and AUX2

buttons.
On the entry panel, press the call key to associate with the internal extension

: an
acoustic signal will confirm that the setting was stored. Hang up the receiver again.
Repeat the same operations for the other extensions.
Exiting programming. Briefly press the PROG button

: the PROG LED goes off. N.B.
If no action is performed, the procedure will automatically end after 30 minutes.
Programming button type. At the “Programming Call Buttons” stage, press the PROG
button

for at least 3 seconds and release it (within 6 seconds) as soon as the PROG
LED comes on and the backlighting on the buttons flashes as shown in figure

,
entring the “Programming button type” procedure.
Press the first button on the entry panel in the position marked

until the backlit LEDS
stop flashing

and remain lit.
At the end, to exit programming, briefly press the PROG button

: the PROG LED goes
off. If no action is performed, the procedure will automatically end after 30 minutes.