CAME EMEGA, Руководство по установке

Страница: 52 / 128

Page
2
0
20 - Manual
FA
01
19
5-
EN
- 0
6
/2
01
8 - © CAME S
.p.
A
.. - The contents of this manual may change, at any time, and without notice. - Translated original in
structions
F 1 Total stop function (1-2)
F 2 Function associated with the 2-CX input
F 3 Function associated with the 2-CY input
F 5 Safety test function
F 6 Hold-to-run function
F 7 Command mode on 2-7
F 8 Command mode on 2-3 / 2-3P
F 9 Obstacle detection with motor at standstill function
F 11 Encoder disabled
F 13 Thrust during closing
F 18 LED lamp
F 19 Automatic closing time
F 21 Pre-flashing time
F 22 Working time
F 25 LED lamp time in courtesy mode
F 28 Speed adjustment during opening
F 29 Speed adjustment during closing
F 30 Slowdown speed adjustment during opening
F 31 Slowdown speed adjustment during closing
F 33 Calibration speed adjustment
F 34 Sensitivity during movement
F 35 Sensitivity during slowdown
F 36 Partial opening adjustment
F 37 Initial slowdown point adjustment during motor opening
F 38 Initial slowdown point adjustment during motor closing
F 40 Initial approach point adjustment during motor closing
F 46 Setting number of motors
F 47 Slowed start during closing
F 50 Saving data in the memory roll
F 51 Reading data from the memory roll
F 60 Sleep Mode function
U 1 Inserting a new user
U 2 Deleting a single user
U 3 Deleting all users
A 2 Motor test
A 3 Run calibration
A 4 Reset parameters
A 5 Number of manoeuvres
H 1 Software version
Important! Start programming, performing these operations first:
1 Motor test;
2 Run calibration.
A2 Motor test
0 = Disabled / 1 = Enabled
Check the operation of the gearmotor and the correct direction of rotation(see motor test paragraph)
A3 Run calibration
0 = Disabled / 1 = Enabled
Automatic door run calibration operation (see run calibration paragraph).
A4 Reset parameters
0 = Disabled / 1 = Enabled
Caution! If necessary, you can restore the default parameters with the following function:
Data reset operation data (default settings) and run calibration deletion.
A5 Number of manoeuvres
1 = 1000 manoeuvres; 100 = 100000 manoeuvres; 1.0 = over one
million manoeuvres
View the number of manoeuvres of the overhead door.
Motor test and calibration menu
Menu mapping