Page
22
- Manual
FA02036-EN
- 12/2023 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
CY input
Associate a function with the CY input.
F3
OFF (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C7 = Reopening during closure (sensitive edges)
C8 = Reclose while opening (sensitive edges)
Safety devices test
Check that the photocells connected to the inputs are operating correctly, after each opening and closing command.
F5
0 =Deactivated (Default)
1 = CX
2 = CY
4 = CX+CY
Hold-to-run
With the function active, the operator stops moving (opening or closing) when the control device is released.
When the function is active, it excludes all other control devices.
F6
0 =Deactivated (Default)
1 = Activated
Command 2-7
Associate a command with the device connected to 2-7.
F7
0 = Step-by-step (default)
1 = Sequential
2 = Open
3 = Close
Command 2-3P
Associate a command to the connected device on 2-3P.
F8
1 = Partial opening
The partial opening time is set from the function [Partial opening time].
2 = Open
Obstacle with motor stopped
With the function active, the gate remains idle if the safety devices detect an obstacle. The function is active when the gate is closed, open or after a complete stop.
F9
OFF (Default)
ON
Gate-open warning light
It signals the gate status.
F10
0 = Warning light on (default) - The warning light stays on when the gate is moving or open.
1 = Warning light flashing - The warning light flashes every half second when the gate is opening and stays on when the gate is
open. The light flashes every second when the gate is closing, and remains off when the gate is closed.
