CAME BPT MTMKB, Инструкция по установке и программированию

Страница: 13 / 32

352*
>3 s >3 s
VA/08 VA/08
beep
352*
>3 s >3 s
VA/08 VA/08
Page
5
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
5
- Manual
FA01405-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
5
- Manual
FA01405-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
Briefl y press the PROG key .
The LED on the entry panel and the PROG LED on the power supply go out.
Exiting Programming
Press the door-release and AUX2
keys and enter the group call code (from
1 to 98) followed by key
:
The call
code is associated with the internal re-
ceiver or the call key chosen
Ⓒ and 倔 .
Continue, repeating the same opera-
tions for all the other internal receivers.
The operation can only be carried out
from the entry panel with the
LED off .
?
To change the entry panel from
which to carry out call programming,
you must press key 1 followed by key
.
Programming the call codes
Press the PROG key until the PROG LED
lights up
.
The LED will fl ash to signal entry into
programming .
PROGRAMMING THE CALL CODES
?
This programming is available only with audio module MTMA/08 and video module MTMV/08.
Call programming associates a call code with each internal receiver.
Going into Programming