2.
Micro USB Port:
For Charging and upgrading firmware. Charging input is 5V/1A.
3.
Antenna:
2.4GHz/2dbi.
4.
Torque Button:
To adjust the torque. Rotate counterclockwise for lighter and clockwise harder.
5.
Limitation Pins
: To adjust the rotation angle of the hand-wheel.
6.
Marking Disk
: to mark focus in the disk.
7.
Focus Knob
: Adjust the rotation angle of the hand-wheel to control the focus, iris, and zoom of the camera
lens with the motor. The rotation angle sensor has a resolution of 12bit.
8.
OLED Display
: Display battery level, connection status, calibration status, travel, memory point, function
menu, etc.
9.
Rec Button
: Tap once to start recording, twice to stop recording.
10.
Photo Button
: Used to focus and take photos. This button is a two-segment button by pressing down.
Press the first segment to focus camera, then press the second segment to take photos.
11.
A/B/C/D Point Button
: First adjust the focus position by adjusting the Focus Knob, and then long press
one of these buttons for 3 seconds to mark the current focus with a result of the corresponding letter will
be displayed on the OLED screen displays. Perform a second long press to cancel the memory focus. The
corresponding letter on the screen will then disappear. The four buttons A/B/C/D can set 4 focus memory
positions. When the memory point is set, tap the button once to quickly switch to the memory focus
position or exit the memory point position.
12.
Function Button
: Consists of 4 direction buttons and OK button. Press the OK button in the main interface
to enter the function main menu. After the function setting is completed, each time you tap the right
button, you can return to the previous interface and repeat the operation to return to the main interface.
Tap the up button once in the main interface to turn on/off the disk indicator.
13.
Lanyard attachment
：
to attach to the lanyard.
14.
1/4 Thread:
to mount unit onto other accessories.
15.
Marking Disk Indicator
: to indicate the marking disk or use as lighting. Tap the UP button once in the main
interface to turn on/off the disk indicator.
Three: Controller Manuel
OLED Manuel Display:
1. CALIBRATE
For the first time use, please calibrate once to check the overall stroke of the lens, so that the controller can
precisely control the stroke position of the camera lens. The motor will automatically record and save the last
calibration data. After this, there is no need to calibrate every time. If a new lens is used, or the position of the
focus motor, or the gear tooth position is changed, the lens stroke will then to be re-calibrated automatically
or manually.
1) AUTOMATIC Calibration
:
If the camera lens has a mechanical limit, it is recommended to calibrate the camera lens with the
Automatic calibration function.
1
2
3
4
5
1 Battery Level
2 Focusing Knob Stroke Percentage
3 Focusing Knob Stroke Progress Bar
4 OK for Calibration complete while TX not
5 Signal Intensity. TX means not connected.
6 Memory point: A B C D
6