1
1
2
2
352*
<1’’
<1’’
F
G
H
Page
4
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
4
- Manual
FA01403-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
4
- Manual
FA01403-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
Press the PROG button briefl y
. The LEDs on the en-
try panel switch off .
Exiting Programming
On the entry panel, press the call
button to be linked to the internal
receiver
1
1
. A beep confi rms
that the setting has been stored
2
2
. End the call and repeat for the
other internal receivers.
?
The operation can only be carried out from the entry panel with the blue LED
off (1 entry panel in
).
To change the entry panel from which calls are programmed, press one of the call buttons on the entry panel
you wish to use for programming.
?
You
can force the switch from one programming mode to another by pressing the PROG button on the
power supply unit for 3 seconds and releasing within 6 seconds. If you force the switch to call programming
from button programming, the button units which have not been programmed are confi gured to 8 calls. If the
base unit is not programmed, calls are not confi gured.
The green LED
fl ashes. Lift the internal receiver
handset (if present) and press the door lock release
and AUX2 buttons
.
Programming calls
