CAME BPT MTMA/08, Руководство по программированию

Страница: 3 / 8

352*
>3’’ >3’’
PROG PROG PROG PROG PROG PROG PROG
1
1
A
B
C
1 1
1 1
1 P.E.
2 P.E. 2 P.E. 2 P.E.
1 P.E.
1 P.E.
2 P.E.
1 P.E.
E D
Page
3
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
3
- Manual
FA01403-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
3
- Manual
FA01403-EN
- 10/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
?
For the basic unit (no call but-
tons), you do not need to press the
buttons that are shown as fl ash-
ing in fi gure
1 1 .
Repeat for all entry panels to be
programmed. Once programming
is complete, the confi guration is
implemented
and you are au-
tomatically taken to “programming
calls”.
Press the fi rst call button on each unit (see “But-
ton numbering” section) until the blue LED and the
button LEDs stop fl ashing.
? The LED lights on the unit remain on to show that
the buttons have been programmed correctly.
Programming buttons
PROGRAMMING ENTRY PANELS WITH VA/08
Entering programming mode
Press the PROG button on the power supply until the
PROG LED lights up.
The LEDs
and and the button LEDs fl ash to show
the buttons are being programmed .