Camco Vortex 2.6, Руководство пользователя

Страница: 21 / 32

CAMCO USER MANUAL
VORTEX POWER AMP SERIES
P.21
5.1 E.U.I. (Extended User Interface)
The E.U.I. slot contains the Rear XLR Panel and the Input Signal Parallel switch as
standard. Other input cards are available
(See 5.1.3 Accessories)
Always switch off and unplug the VORTEX from mains, when working on the
E.U.I.
The switches described below are not readily accessible and cannot be
checked visually from the outside.
To remove the E.U.I. unscrew the two Phillips head screws at the left and right
end of XLR-Panel and carefully slide out the E.U.I. To refit the E.U.I into the
VORTEX , carefully insert the PCB in the guide-rail (left/right) and slide it in.
Don’t forget to replace the screws!
5.1.1 Input Signal Parallel Switch
If you want to hard-wire the XLR input connectors together on the E.U.I., just
change from Stereo to Mono using switch S1. Be careful when you do this!
(See section 3.7, Input Signal Chaining)
5.1.2 Filter On / Off Switch
If a filter is present on the E.U.I. this can be activated or ignored using switch
S2.
5.1.3 Accessories
Different types of filters are available. For further information contact your
dealer or
CAMCO
5.1.4 What Are The Possibilities Using The E.U.I.?
The E.U.I. is a very powerful interface, which allows access to most of the system
parameters.
For example: volume, input signal, mute, output current, clip signal,
temperature and more. It makes it possible to utilise filters, remote control,
signal processing, and more… Please contact your dealer or
CAMCO to
customise the E.U.I. according your wishes.
5.2 C.A.I. (Camco Audio Interface)
5.2.1 Camco Audio Interface
CAI is a bus system, in which all significant device functions can be monitored
externally and remotely controlled using a master PC. Up to 99 devices can be
controlled in parallel in each phase of the bus system, which simply consists
of a two-core insulated cable. The master can serve several phases for larger
applications. For more information, please contact your dealer or distributor.
5.2.2 Wiring
To connect the VORTEX to your C.A.I. - system use a fully-wired telephone-type
cable with RJ45 connectors. You can chain several VORTEX amplifiers using the
second C.A.I. Connector on each amplifier.
5.2.3 CAI Address Settings
The CAI address selection procedure will not affect the operation of the
VORTEX but whilst this procedure is active, the Volume cannot be adjusted by
using the Pots.
Note: Ensure you return both pots to their original position after address
selection is complete, otherwise the amplifier will change its volume level
to the new pot positions!
5.0 OPTIONS