CAMBRIONIX TS2-16, Руководство пользователя

Страница: 12 / 38

TS2-16 Page 11 of 36
5. Using your TS2-16
In this section, you can find information using your hub in charge or sync application. You can
also find information on managing your hub, changing port modes, connecting multiple hubs to
one host and using Cambrionix Software.
5.0.1 LED Configuration
Your TS2-16 has inbuilt LEDs used to show the state of the ports or devices. These LEDs can be
configured to support your use case; this can be controlled either by using the API to send
commands directly or through separate software.
The default LED behaviour of the hub is below.
Colour Behaviour
Flashing Red Port is in charge mode and is profiling the device
Red Port is in charge mode and is charging
Yellow Port is in sync mode and has a host connection
Green
Port is in charge mode and the device has reached the
charged threshold
5.1. Using without connecting to host
When the Hub is switched on and is not connected to a local host computer it is
automatically configured to charge devices using its intelligent charging algorithm. Connect the
devices to be charged to any of the available ports (not the Host Port) using
USB - compliant cables.
Once the devices are connected, the algorithm will detect the highest charge rate allowable for
each attached device. Charging at the optimum rate (up to 2.4A) specified by the manufacturer
will commence once profiling is complete. Depending on the state of charge of the device
attached, this may take tens of seconds.