11
Mounting the Satellites
To the monitor
To mount the satellites to the
side of a monitor, use two of the
self-adhesive “hook and loop”
fasteners per satellite (see
diagram G).
To the wall
To wall-mount the satellites on
structurally strong surfaces
(a wall stud or wood paneling),
screw the M5X25mm screws into
the material. Allow their heads
to protrude about ¼ inch to fit
into the keyhole slots on the back
of each cube (see diagram H).
The plastic anchors supplied
will be needed to secure the
screw in most wall surfaces. If
so, drill ¼-inch holes in the wall,
then tap the anchors into the
holes until they are flush with
the wall. Then screw the screws
into the anchors until they
protrude about ¼ inch.
Be sure to apply the stick-on
rubber feet to the back of the
satellite cubes. This assures an
acoustically secure installation.
G
H
SWDrev.fm Page 11 Tuesday, October 17, 2000 2:03 PM
