Cambridge SoundWorks OontZ Angle 3, Быстрый старт

Страница: 16 / 24

- Plug one end of a 3.5mm audio cable into the AUX IN Jack on the
back of your speaker.
- Plug the other end of the 3.5mm audio cable into the headphone
jack on your laptop/computer or non-Bluetooth audio device.
- Make sure both ends of the cable are fully inserted
- You are now ready to play.
- Make sure your OontZ Angle 3 battery has a sufficient charge
Page 14
Turn ON your OontZ Angle 3
To Play with Non-Bluetooth Audio Source Devices
Use a 3.5mm Audio Cable
Important: The Bluetooth on the OontZ Angle 3 is disabled when a 3.5mm audio cable is connected to the speaker.
You need to remove the 3.5mm audio cable from the speaker in order to connect to a Bluetooth device.
- Note: When the rubber flap is open to allow a 3.5mm audio cable to be connected, the speaker is not water resistant.
The rubber flap needs to be closed to keep the speaker water resistant.
- Note: The volume control on your device and the speaker work independently of each other. To play the speaker at the loudest
volume, set the volume on your device to maximum and raise the volume on the speaker to maximum.